Other Services
- Custom Shims and Spacers
- If you have a requirement that cannot be filled by a catalog item, Douglas Stamping Company specializes in fabricating and stamping shims for specific needs. We fabricate any shim, spacer or washer, out of a wide variety of materials including laminated shim stock, plastic, non-ferrous and stainless steels. Contact us to discuss your needs!
- Inventory
- We are constantly adding new parts to our inventory. If you have a
specific part number or requirement not shown in this catalog, please
give us a call to discuss your needs. We areexperts in manufacturing prototype shims,
spacers and washers in long and short runs.
-
Prototype Work
- We are pleased to offer our services in the area of short run prototype
work. Our expanded capabilities now allow us to produce a variety of
stamped, turned or machined parts, from single piece to production
quantities. Give us a call to discuss your specific requirements.
- Electro-Etching
- If your parts require an identification number or other marking, we can
help. We have equipment to mark most metal surfaces with almost any sort
of finish. Please call us to discuss your needs.
- Vibro-Tumbling
- Short run tumbling, degreasing and deburring is also available for your
parts. Contact us to discuss your requirements.
- Raw Shim Stock
- Small quantities of full hard No. 2 finish shim stock are available from
us at very reasonable prices. Widths are stocked up to 6 inches in most
commonly used inch/decimal and metric thicknesses, such as
.125", .060", .030", .015", .25MM, .50MM, 1.00MM and 2.00MM. We also
carry other materials, including brass, copper and stainless steel. Please
give us a call and let us quote your raw stock requirements.
|
